News
News
Key Welding Technology for High-Neck Flange and Steel Pipe Joints
- Posted: 01/28/2025 06:01:04
- Hits: 7
Abstract The core technology in steel pipe tower fabrication is the welding of high-neck flanges to steel pipes. An enhanced welding technique has developed, building on the original process. This new method not only ensures a high first-time pass rate but also improves production efficiency, facilitating...
The Design and Calculation of Stamped Lap Joint Flanges
- Posted: 01/08/2025 06:01:53
- Hits: 6
The Design and Calculation of Stamped Lap Joint Flanges This study introduces the steel stamped lap joint flange, a novel non-standard pipe flange, and examines the feasibility of applying the widely used Waters for its design and calculation. The analysis provides an outlook on the theoretical calculations...
Development of Manufacturing Large Anchor Flanges
- Posted: 12/24/2024 03:12:27
- Hits: 5
Abstract This paper examines the research, design principles, and production techniques for anchor flanges, which are vital support components in large-scale gas and oil pipelines operating under high pressure and spanning long distances. By prioritizing advanced and practical design principles, domestically...
Hardfacing the Inner Surface of Long-Neck Flanges Using CO₂ Gas-Shielded Welding
- Posted: 12/07/2024 02:12:10
- Hits: 5
Abstract A corrosion-resistant stainless steel layer is applied to the inner surface of the long weld neck flange on pressure vessels to enhance its resistance to corrosion. This paper discusses the application of CO₂ gas-shielded welding with stainless steel core wire and appropriate welding auxiliary...
UHV High-Neck Flange Welding
- Posted: 11/27/2024 03:11:14
- Hits: 8
3. Requirements for Welding Seams of Circumferential Butt Joint of UHV High-Neck Flanges During the production of steel pipe towers for UHV transmission lines, the welding of steel pipes to high-neck flanges is critical to the quality and progress of the entire project. Therefore, when dealing...
Application of High-Neck Flange to UHV Steel Pipe Tower
- Posted: 11/05/2024 02:11:15
- Hits: 11
The high-neck flange, also known as a long-neck flange or neck flange, is a disc-shaped component primarily used to connect pipes. It has been widely applied in petrochemical, urban water supply, and power systems. In recent years, with the planning and construction of the UHV transmission line project...
Analysis of the Cracking Cause of High-Neck Flanges
- Posted: 10/28/2024 11:10:48
- Hits: 18
Abstract: A stainless steel high-neck flange cracked after being welded and installed. The causes of cracking and failure of the high-neck flange were analyzed through macro and fracture analysis, chemical composition analysis, mechanical property tests, and metallographic inspection. The results...
Anchor Flanges for the East-West Gas Transmission Project
- Posted: 10/17/2024 10:10:03
- Hits: 6
This paper analyzes and improves the original anchor flange structure used in domestic and international pipeline project designs, considering the relevant requirements for anchor flanges in the East-West Gas Transmission Project in Sichuan. A new type of staggered flange structure is proposed, which...
Analyzing the Corrosion of Blind flanges
- Posted: 08/27/2024 06:08:34
- Hits: 12
In the reforming unit of a continuous reforming device, the materials need to pass continuously through four reactors for the reaction. Each reactor has a heating furnace that provides the necessary reaction heat. Technologically, the four heating furnaces are combined into one to form a "four-in-one"...